General Requirements

Introduction

The Flexiloo luxury toilet system is designed to fold for transportation and is fully portable and easily moved and installed by one person using the Flexiloo trolley. It is intended to be installed in covered areas and is not suitable for use outside without suitable protection from weather, e.g. building, marquee or temporary structure.

There are modules to provide cubicles, urinals and vanity units with accessible modules available early 2008. As each module width is based on multiples of 0.9m it is possible to install the modules in any order to provide flexible arrangements for any number of guests or configuration.

Each module is based on a strong, rot free fibreglass sub floor which can be adjusted with shims but it is necessary for the installation site to be firm and level. Panels are a lightweight composite construction with high pressure laminate surfaces for easy cleaning.

The system is primarily designed for use with vacuum drainage with low water usage and no need for chemicals but can be manufactured with a conventional gravity system if required.

System Requirements

SITING - A firm level base protected from weather. Minimum access width 750mm.

POWER - A basic 3+1 setup will need 1x13amp single phase supply (240v) for the pump assembly (1.5kw) and 1x13amp single phase supply (240v) for water heating and lighting (3kw). Larger installations will require additional supplies depending on total equipment provided.

WATER - One supply normally required @ minimum 1 bar but can be supplied using tanks and booster pump if necessary.

Datasheets

Toilet Cubicle

Width			0.9			0.9m
Depth	FOLDED		0.69	ASSEMBLED		1.8m
Height			2.275			2.2m
Weight	180 kg (approx. depending on model)

Standard toilet fitted	Jets 64 FD/VPC
Water consumption (per flush)	0.8 litres (adjustable)
Lighting	1x13w fluorescent
Power connection	1 x system connection in
	1 x system connection out

Urinal Unit

Width			0.655m			1.8m
Depth	FOLDED		0.925	ASSEMBLED		0.9m
Height			2.250m			2.2m
Weight	150 kg (approx. depending on model)

No. of urinals	3
Lighting	3 x 13w fluorescent
Power connection	1 x system connection in
	1 x system connection out

Vanity Unit

Width	0.9m
Depth	0.6m
Height	2.2m
Weight	75kg (approx. depending on model)
MASTER UNIT ONLY	Automatic infra red tap (depending on model) 2.2kw 240v water heater 240v distribution board with RCD and circuit breakers
Lighting	2 x 240v 50w halogen
Power connection	1 no 16amp 240v-in 4x system connections-out
SATELLITE UNITS	Automatic infra red taps (depending on model)
Lighting	2 x 240v 50w halogen
Power connection	1 x system connection in 1 x system connection out
Nb A maximum of 3 satellite units per master unit. At least one master unit needed for each installation.